Ask any HVAC technician in Johns Creek and you will hear the same thing: equipment almost never breaks down on a mild day. It waits for a heat wave or a hard freeze. What makes repair tricky is that very different faults look identical from the thermostat. If the system runs but cannot hold temperature, the cause could be a failing run capacitor, pitted contactor points, a refrigerant leak, a fouled flame sensor, or just a filter packed so tight that airflow collapses. If it will not start at all, look to a float switch tripped by a clogged condensate line, a dead transformer, a faulty thermostat, or a control board that no longer sequences the equipment.
Most of our service calls are for AC Repair and Furnace Repair. That's the place to start if you need a fix today.
Warning Signs for HVAC Repair
Catching these issues early helps you avoid costly problems. Keep an eye out for the following clues:
- An outside unit that buzzes but will not start
- Unfamiliar sounds from the equipment, like squealing, grinding, or banging
- The system short-cycling on and off without reaching the set temperature
- Higher energy bills with no improvement in comfort
- Air at the registers that is the wrong temperature for the mode you selected
- Barely any air coming out of the vents
- A breaker that trips whenever the system tries to run
- Water pooling around the indoor equipment, often from a clogged condensate drain
Act Before It Gets Worse
A failing capacitor, clogged condensate drain, or dirty flame sensor rarely fixes itself and usually gets more expensive to address the longer it runs. If you notice any of these signs, call (470) 200-3164 for a prompt inspection.
